[michael hoskins]

I have pulled the rt. side cover off in the foot well and still can not see where to connect the OBD-2 tester on my 01 A/M DB7 V12. Any help would be welcomed. Thanks Michael

 

[WayneB]

You need to pull off the lower right side dash panel (the one under the srs airbag) and on the left side you will see the 2 OBDII ports .

Just get your fingers in the joint between the two panels and carefully pull and the lower panel which is held on with spring clips will hinge down.

 

[michael hoskins]

Thanks, I found it, and plugged my new INNOVA 3100 OBD-2 with ABS in, it did not read ABS codes, called their tech support line and they told me that none of their testers will read ABS codes on either my Aston or my Bentley and most likely not on the Ferraris either, but it will read other codes so not all is lost, and it's been a good learning process. I paid less than 90$ for a new tester, not a bad deal. Thanks for your help.
Michael

 

[Squid]

The ABS system will be on the other OBD connector.

when I get my Technical manuals from my office I can provide the correct pins and the data protocol they use.